Product name
PE sensor
Extreme high temperature PE accelerometer

Model

372P-50

Series

372P

Feature / Application

• Triangular structure

• Screws or stud mounting

• Hermetic seal

• Case isolated

• High level output


•Vibration monitoring

•Engine testing

•Aircraft research

•Modal analysis

•Exhaust system testing

Product Introduction

Model 372P is a piezo-electrical accelerometer permitting high temperature vibration measurements. 372P features a shear mode ceramic crystal which exhibits excellent output stability over time. With the benefit of special piezo crystal, The accelerometer transmit the acceleration signal by charge output through the low noise cable. Signal ground isolated from the outer case of the unit. The welded Inconel construction provides a hermetic housing high temperature application. The miniature 7/16-27 glass insulated connector provides long-term stability over the operating temperature range. The 372P has triangular through holes for M4 screws mounting on the test object. The 372P provides wide frequency response, which is ideal for dynamic vibration and shock measurement. Senther’s model 17P-L is a 7/16-27 to BNC breakout cable for the sensor. IN-17 charge amplifier is recommended when 372P work under high temperature environment that may cause the lower sensor internal resistance.

Product specification
Range(g) 1000
Velocity Range(in/s) 0
Sensitivity( ±10%) 50
Frequency Range(Hz) 0.1 - 5000
Weight(g) 95
Shock Limit 5000
Operation Temp(°C) -55 to 482
Output Type Charge
Axial Single axial
Mounting Screw/Stud
Temp.Signal N/A
Sensor Type PE Accelerometer
Sens. Unit pC/g
Excitation No need
Mating cable 17P