Product name
IEPE sensor
Single axial AC-Response (Dynamic) accelerometer, 10-32 top exit connector

Model

511A-1000

Series

511A

Feature / Application

• Miniature Size

• Adhesive or stud mounting

• Hermetic seal

• Annular shear mode

• Wide frequency response

Product Introduction

Model 511A is an IEPE single axial accelerometer permitting simultaneous shock and vibration measurements. 511A features an annular shear ceramic crystal which exhibits excellent output stability over time. The accelerometer incorporates an internal circuit with TEDS(optional) in a two-wire IEPE system which transmits its low impedance voltage output through the same cable that supplies the constant current power. Signal ground is connected to the outer case of the unit. Isolated mounting studs or housing are available. Polarity inversion protection for the amplify circuit is inherent in the circuit design. The welded stainless-steel construction provides a lightweight hermetic housing. The miniature 10-32 glass insulated connector provides long-term stability over the operating temperature range. In addition to adhesive mounting, the 511A has 10-32 threaded holes for stud mounting on the test object. The 511A provides wide frequency response, which is ideal for dynamic vibration and shock measurement especially for lightweight structures and drop testing for the packaging industry. Senther’s model 11-3 is a 10-32 to BNC breakout cable for the sensor.

Product specification
Range(g) 1000
Velocity Range(in/s) 0
Sensitivity( ±10%) 5
Frequency Range(Hz) 0.5 - 15000
Weight(g) 8
Shock Limit 5000
Operation Temp(°C) -50 to 125
Output Type IEPE
Axial Single axial
Mounting Adhesive/Stud
Temp.Signal N/A
Sensor Type IEPE
Sens. Unit mV/g
Excitation Constant current: 2~10mA
Mating cable 11